What should we pay attention to when the trailer drags the faulty car?
When the vehicle is out, it will inevitably have various problems. Some need to be handled simply. Some need to use machinery to deal with it. There is also a situation where the car can't go straight and needs to be called a trailer. Then the trailer is in What do we need to pay attention to as the owner of the vehicle when dragging the vehicle, and where to pay attention, the following Electric Drum Brake Wholesaler begins to introduce the things to be aware of when towing the faulty vehicle:
Electric Drum Brake
If the Electric Drum Brake is damaged or the steering mechanism is faulty, use a hard mop and do not use soft mops.
Before starting, you should carefully check whether the tow rope or the towing bar is firm and reliable. When starting, honk the horn to inform the rear car. After the driver of the rear car knows, start with the low-speed gear and slowly straighten the tow rope; When there is resistance, gradually increase the throttle, keep enough power, and drive smoothly. The electric drum brake is a block brake that is centrifugally driven by a motor to drive a lever system. The structure is simple and convenient to manufacture, but since the lever system has large inertia when working, its operation is sluggish. The brake that is braked on the brake wheel by the brake block. The pressure of the brake pads on the brake wheel shaft is large and uneven, so a pair of brake pads are usually used to offset the pressure of the brake pads on the brake wheel shaft. The Electric drum brake is available in both external and internal versions.
The driving speed should be kept even, don't be slow and slow, and prevent the rope from being pulled loose when it is pulled. The handling situation should be notified in advance of the car, and emergency braking should not be used. The shifting action during driving should be accurate and rapid, and the linkage should be stable. When the low gear is changed to the high gear, the driving distance should be appropriately increased; when the high gear is changed to the low gear, the shifting time should be appropriately advanced.
The detoured section should be decelerated in advance, and the rear car should be indicated by lights, horns or gestures, and travel as far as possible on the outside of the curve. If the tow rope is too long to prevent the rear car from turning, the tow rope should be shortened for smooth passage. When driving downhill, the front car can accelerate the speed of the car to prevent the towing rope from being loose and make the rear car difficult to control.
The driving route of the rear driving should be the same as the front car or slightly to the left side of the front car, to maintain the braking air pressure or the good performance of the parking brake, flexibly use the brake to keep the drag rope straight, to prevent the drag rope from slackening. Entering the front wheel, causing an accident. When going downhill, you can hang the shift lever into the low speed gear and step on the clutch pedal. When deceleration is required, the clutch pedal can be lifted and the speed of the engine can be controlled by the drag effect of the engine. At the same time, always pay attention to the signal from the front vehicle, ready to take corresponding measures, in case of circumstances, use the horn to warn the front car. In case of emergency braking in front of the car, the front of the car should be hit a little inside, in case it stops and hits the front car. Our company also has the Railer Backing Plate on sale, if you are interested if you need it. Welcome to consult.
